Guides / Adding funds

1. 1

   Open your deposit details

   Go to Profile and choose Deposit. The panel shows your cash wallet address and a QR code for it.

2. 2

   Check the network

   Send on Robinhood Chain, chain id 4663. This is the single most common mistake. The same address on another network is not monitored by the app.

3. 3

   Send USDG

   Transfer USDG to that address. The app also recognises ETH and WETH on the same chain and shows them on your profile, but USDG is what trading spends.

4. 4

   Wait for it to appear

   Balances are read from the chain, so the deposit shows up as Cash in the header once the transfer confirms. Reload the profile page if it lags.

#Keep a little ETH

Robinhood Chain charges gas in ETH. Trading itself is sponsored, but transfers you initiate from the profile page are ordinary transactions, so keep a small ETH balance in the cash wallet. A dollar or two of it is plenty.

#If your deposit has not shown up

• Confirm the network. Check the transaction on the Robinhood Chain explorer. If it is not there, it went to another chain.
• Confirm the address. Compare it against the one shown under Deposit, not an address you saved previously.
• Confirm the token. Only USDG counts as cash. Another stablecoin on the same chain will not be picked up.
• Give it a moment, then reload. Balances are fetched, not pushed, so a hard reload is sometimes all it needs.

#Withdrawing

The same profile page sends USDG, ETH, or WETH back out to any address on Robinhood Chain. Anything currently held as a position or as pUSD has to be closed and converted back first, which is covered in closing and cashing out.